Turnout construction method: quality requirements. Flatness and geometry of the track bed. After compaction paving the track bed of iron ore production plant turnout, visually flat surface, the track bed thickness should be lower than the design 30mm, ballast surface flatness ruler with 3m check each direction error should not be greater than 10mm iron ore price turnout, turnout around 30m should be prepared within the scope of the downslope. Track bed density is not less than 1.7g / cm3. Turnout loading, unloading. Tip rail and rail center in the handling, laying process easily deformed. Therefore, iron ore turnout wholesale switch rails and basic rail assembly, with movable frog assembly, with a length of more than 15m of track and boxed parts are using a large crane mechanical handling. Turnout handling, transport and storage: When using a large crane mechanical handling difficult, excavators or forklift unloading, unloading choose this way, must be equipped with safe and reliable wire rope, lifting points and choose a good position to prevent the rail material tilt. At the tip rail and basic rail assembly, the assembly may be tempted pillow, landing point must be the bottom plane of the workpiece to prevent the workpiece side ground first cause deformation of the workpiece. Turnout main parts removed should be stacked on a flat site, not free to pile up in order to avoid distortion, resulting in greater quality changes. High quality iron ore turnout _ Xin Yang Machinery (certified) _ Gansu Linzhou Iron turnout by Xin Yang Machinery Industry Co., Forest City Xin Yang Machinery Industry Co., Ltd. (www.lzxyjx.com) Henan, railway, subway Equipment leader with over the years, the company implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customers needs. Xin Yang Machinery leadership in the staff warmly welcome all inquiries negotiations to create Xin Yang Machinery a better future.